Totally satisfactory - as compared to other products in its price range has an excellent price / performance ratio. 3 high-bright LEDs have sufficient power at a really decent efficiency. Conventional batteries / accumulators (ie. Eg. The classic 3 x AAA, Sec. Approx. 300-600 (?) .. MAh) when set to Auto // ir * * // motion sensor can withstand a busy place (in my case entrance hall to the apartment) very decently powered device for about 2-3 weeks. Then, the luminous intensity has not staggering, but still decent and the LED are still working as 2-3 months. If you own / dokoupíte a battery and charger, then I dare say that it would not happen to supply a bigger problem. Fashion Auto / On / OFF in my more than enough for most situations - in "Auto" mode can not be set lighting time (set in the interval about as 28-30s from ir sensor activation, automatic off ((that is, if the sensor does not detect been further movement / heat ..)), but rarely will probably need more settings. On / Off Switch => same as a standard flashlight. Fastening is designed plastic part for about 1.5 x 1.5 cm, which can be attached by two holes screws, bolts etc. - or you can "mount" using a magnet stick to the metal substrate. From the beginning I had this piece stuck, but if you remember, he had quite a decent magnet efficiency. On the side lamps is molded into the plastic hole in which the holder snaps and holds very well. Smaller lack is precisely the size of the holder so although it is very convenient to remove the lamp, the worse it is its deployment Z5. So if you often transmit the lamp, I recommend it to place the max. eye level. Personally, it vyndavám of the holder at least so therefore I can not judge, how many cycles of removing the plastic can withstand, but the process and materials used seem quite resilient. Ir sensor is working properly and under plastic is also a photocell, which in Auto mode at a fixed set ambient light intensity circuit shuts down. This device thus saves precious mAh :) reflector is associated with a small neck with sensors via a hinge that allows filming mounted lamps in the range of approx. 30 degrees on each side. Overall, I would probably assessed as 4 * - point downwards uncomfortable deployment Z5 in option holder attached firmly to the ground, but in this price Cat. I deserve full number. I recommend ˘˘˘
Well-chosen LED - Luminosity Mobility variants fit Decent battery life / efficiency in the price range is quite sufficient
In the case of attachment bracket "on the hard", eg. By screwing or gluing is deploying lamp back a bit uncomfortable due to the small size and design. But there is a possibility to use mounting bracket using a magnet, then this problem is eliminated.
Translated by Google Translate